Cyclamen breeding skills

Cyclamen breeding skills :

The breeding point of a cyclamen: the seeds are full, the flowers are sterilized, and the ramets are easy to survive.

The seeds of cyclamen are usually planted in autumn. The seeds are not only large, but also full. We wash the seeds first, then soak them in sodium phosphate solution for 10 minutes to eliminate the poison, or soak them in warm water for germination for one day. Don't be busy planting after soaking seeds. It is better to put them in loose and fertile sand at room temperature for two days. After that, pay attention to moisturizing and heat preservation. Generally, you can germinate after one month of sowing. The time of ramets is generally selected after the cyclamen flowering. The cool weather in spring does not rot the wounds of the ramets. We carefully take out the spheroid roots of cyclamen and cut them according to the distribution of buds to ensure that each ramets are There is a bud eye, then the grass is smeared with some ash and then transplanted into other potting soil for compaction. After the ramification, the water should be poured, and then placed in a cool place.

The main points of maintenance of the two cyclamen: watering should be wet, not suitable for fertilization, should be thin, not suitable for concentrated light, should not be hot

1, watering should not be wet: always keep the soil moist roots do not accumulate water

Cyclamen has some contradictions in water absorption. It likes the moist environment very much, but it is afraid of too much water. Therefore, when we water it, we need to pour a proper amount of water every day to keep the soil moist. To control the amount of water, it is important not to accumulate water on the soil to prevent the water from corroding its roots. In the summer, you should spray more water to ensure normal water absorption.

2, fertilization should be thin and not thick: every 10 days in the growing season, apply a thin fertilizer or less or no nitrogen fertilizer

Cyclamen is a relatively fertile plant, but it is a thin fertilizer, especially in its growing season, we will give it a thin fertilizer every ten days or so, and wait until the cyclamen come to the bud. It is necessary to apply a liquid fertilizer again. When the flowering period is as little as possible, even if the fertilizer is applied, the thin fertilizer will be applied occasionally, and the nitrogen fertilizer should not be applied. Be careful not to pour the fertilizer directly onto the leaves when fertilizing, otherwise it will be easily corroded.

3, the light should not be hot: the sun should be warm and the summer should be protected from direct sunlight and shade

When the sun is warm and not glaring, you can let the cyclamen receive more sunlight. The abundant sunshine is conducive to promoting the flowers. In the summer, try to put the cyclamen in the place where there is scattered light. If necessary, Shade it to avoid being sunburned by the hot sun.

Not only that, the cyclamen breeding site must have good ventilation conditions, otherwise the weather is too sultry and the surrounding environment is not ventilated, cyclamen can easily sleep. In addition, the suitable temperature is also very important for the growth of cyclamen. Try to maintain at 20 degrees during the day. When the summer is overheated, you must do a good job of cooling and shading. In winter, the indoor temperature should not be lower than ten degrees, otherwise it will affect The normal growth of cyclamen.

columnar activated carbon

Columnar Activated Carbon,Wooden Column Of Activated Carbon,Anthracite Column Activated Carbon,Coal Based Column Activated Carbon

Ningxia Jinyihui Environmental Protection Technology Co., Ltd. , http://www.chinajyhhb.com