How to renovate second-hand housing second-hand housing 6 elements
At present, the heat of the second-hand housing transaction market is still high, and many owners will go to buy second-hand housing. First, the price is relatively lower, and second, the geographical position has more advantages. After the second-hand house has been hand-selected and cleaned directly after the arrival, there are also refurbished and then stay, then how to renovate the second-hand housing it? Let's take a look at the six elements of a renovated second-hand house.
Second-hand housing how to decorate the elements, aging water pipes must be replaced
The original waterway pipeline of the second-hand housing must be replaced, not only because it is aging, but also because of its unreasonable layout. Therefore, during the renovation, it is necessary to thoroughly examine it to see if there is corrosion and aging. Unreasonable and so on, it is best to replace all of them with copper tubes, aluminum-plastic composite tubes or PP-R tubes.
Second-hand housing how to decorate the elements Second, the circuit can not be transformed, the outlet must increase
Circuits are simple and wire aging is a common phenomenon in second-hand houses. It may not be able to meet the electricity needs of modern people and must be rewired and rebuilt. The wire should be replaced by a 2.5 mm square section of copper wire. The number of fixed sockets during the renovation should not be less than 12. Otherwise, the use of mobile sockets in large quantities will increase the current load and bury hidden safety hazards.
Second-hand housing how to decorate the elements of three, "hidden project" to open again
The quality problems that often occur in second-hand housing are mostly caused by improper construction of “hidden projectsâ€. Therefore, in the decoration, we must pay special attention to do a good job in all aspects of the inspection work, the legacy of the "hidden project" removed to eliminate hidden dangers.
How second-hand housing renovation elements four, three "face" transformation is essential
Second-hand housing renovation can not ignore the wall surface, ground and ceiling reconstruction, it should first carry out on-site inspection to see whether there are obvious cracks, leveling are all and whether there is no sand phenomenon, etc., in some cases, we must carry out appropriate repair work, repair After brushing a primer, it is also necessary to ensure that the air is clean and protected against dust during construction.
How second-hand housing renovation factor five, doors and windows update carefully consider
Even the sturdy doors and windows must be repainted so that they can be coordinated with the entire home. If the windows and doors have skinning, deformation, etc., then it must be replaced.
How to decorate second-hand housing factor six, in the demolition of old tiles resurfacing, but also pay attention to two points
1. If you are unsatisfied with the existing spatial pattern, then you must see the demolition and reform. At this time, when you break the wall and the ground, you must avoid the clogging of the sewer.
2. The waterproof work of the second-hand housing should also be handled well. The waterway is best to use less elbows so as to avoid poor water flow or blockage.
Editor's Note: The above is about the six elements of how to decorate the second-hand housing, in fact, second-hand housing renovation is similar to the rough housing, and even more to do some demolition and renovation projects. I hope Xiaobian's sharing can help you, and I would like to know more about the decoration information. Please pay attention to this website.
3M Measuring Tape,Waterproof Tape Measure,Stainless Steel Tape Measure,Plastic Tape Measure
SHANGQIU CHAOYUE MEASURING TOOLS CO., LTD , https://www.calibrateds.com