MCH-6 air-filled pump has a high market share and is mainly used for inflating (filling) air-breathing cylinder. Product quality, product compression air quality, in line with the highest European standards-EN12021 standards. MCH-6 air-filled pump mainly by the chassis, compressor body, drive motor, filter system. MCH-6 air-filled pump works as follows: Pure air through the air filter, filtered by a cylinder inlet valve into the first cylinder, the first cylinder compressed, through a cylinder exhaust valve into the first cylinder Cooler, cooled gas into three cylinders, the three cylinders, the compressed gas through the secondary cooler, the cooled gas into the four cylinder, the gas compressed by the four-cylinder into the four-stage cooling Compressed and cooled gas into the oil-water condenser, into the activated carbon molecular sieve filter, filtered pure air through the hose discharge. During operation, the compressor temperature is high, do not touch! MCH-6 air-filled pump installation and use: 1. Place the unit on a horizontal surface; 2. Ensure that the installation area to ensure good ventilation and cooling unit; 3. To ensure that the installation area is free of dust, explosion, corrosion and fire hazards. 4. When the unit is operating at an ambient temperature above 40 °, use air conditioners to cool the space used. 5. Make sure the unit is more than 1M from the wall; 6. Make sure the unit is more than 1.5M away from the ceiling; 7. Make sure that the installation area is well illuminated and various parts and indicators are clearly visible. MCH-6 Air Filled Pump Maintenance: Lubricant Replacement: The compressor must be changed for the first time after 25 hours of operation during the break-in period, and will be changed every 50 hours of operation thereafter. If the machine is not used for a long time, it should be commissioned once every three months. Lubricants in a compressor can take longer to expire, so change every year or season depending on the season. Correct use of ordinary lubricants (such as car lubricants, etc.), otherwise it will cause serious damage to the compressor. In addition, common lubricants due to high temperature pressure and toxic substances may cause cancer. Let the compressor run for 2-3 minutes without pressure before each oil drain, which facilitates the mixing of the lubricant in the cylinder and the discharge of the impurities therein. Filtration system maintenance: Filtration system is divided into air filters and activated carbon water filters, air filters located in the air intake, the compressor did not work 25 hours need to check once to prevent the air intake due to too much dust plugged. Too much dust can be washed with water and detergent, air-dried can continue to use (recommended replacement). If it can not be used again, it must be replaced. Activated carbon oil-water filter compressor needs to be replaced after each 50 hours of work, if not long-term replacement, activated carbon will not be saturated after filtering, when inflated will be mixed into the oil gas cylinder gas odor, harmful to human body . Excessive time may also lead to oil filter damage, after the damage activated carbon will leak and cause condensation of the condenser tube and cause damage to the compressor.