Surface quality of single-gated T-slot platforms. Colorimetric test. And in the course of its use, special attention should be given to avoid the workpiece and the flat face of the work have an extremist collision, to prevent damage to the work surface; the weight of the workpiece can not exceed the rated load of the plate, otherwise it will result in lower quality work, there may be damage to the plate Of the structure, and even cause deformation of the flat, so damaged, can not be used. Single-T-slot platform Specifications: There are specifications: 100 * 100-3000 * 6000 but failed to full column, . Level 0, Level 1 T-slot platform around 25mm square on each side of not less than 25 points. 3-level single T-slot platform on each side of 25mm square within the scope of not less than 12 points. 2 level single T-slot platform 25mm square in each side of the range of not less than 20 points. Single T-slot platform Accuracy: According to the national standard measurement verification procedures, respectively, 0,1,2,3 four levels. 3-level accuracy above the single-T-slot platform used for inspection, marking, assembly and other use of the following four-level accuracy of the single-T-slot platform is generally used for welding and other use. Single T-slot platform uses and materials: single-T-slot platform for a variety of inspection work, the accuracy of the reference plane for the measurement of mechanical inspection test machine tool base, inspection, and precision parts for the dimensional accuracy or deviation, And for precision crossed, in the machinery manufacturing is also an indispensable basic tool. Single T-slot flat plate (single T-slot platform) Material: high strength cast iron HT200-300 working surface hardness HB170-240, by two manual processing (artificial annealing 600 degrees -700 degrees and natural aging 2-3 years ) The accuracy of single-circumference T-groove platform is stable and its wear resistance is good when it is used, and the accuracy of single-circumference T-groove platform is stable after two manual treatments (artificial annealing of 600 ° 700 ° and natural aging of 23 years) Good grinding performance.