Home>Bearing knowledge>Oscillation motor inlet bearing device tips

/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Device for oscillating motor bearings

---

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

The imported bearings replace the new time of the oscillating motor; the effect is different; and it is necessary to use the same bearing as the original type; and the role embodied in this aspect has a better meaning; This aspect shows a better effect. Firstly, the condition of the imported bearing is analyzed from the following conditions.
When the oscillating motor is replaced with a new one; it is necessary to use the same bearing as the original type.
1) The bearing is washed with kerosene; press in the bearing seat; fill the shell of the outer ring of the bearing with Shell No. 3 lithium base grease to two-thirds full; apply uniform with the net hand; install the bearing gland; The bolts of the bolt-proof rubber are pressed against the bearing gland.
2) The bearing is a detachable cylindrical roller bearing in the front and back; the bearing should be placed on the rotating shaft and in place.
3) Mount the bearing housing on the casing; if there is a grease oil filling hole; it is necessary to align the bearing. Press the fastening bolt with the anti-loose rubber to press the bearing seat.
4) The painful block in the watch is mounted on the rotating shaft and is in place; if there is an axis key, the axis key should be installed in the keyway and then the external pain block should be installed; the shaft retaining ring is mounted on the rotating shaft.
5) Tightly fix the bite block fastening bolt; change the adjustable bite block; make it reach the position of the viewpoint before the unloading and tighten the fastening bolt. After the above assembly is completed; the shaft should have a certain axial movement,
6) Shield on both ends of the upper oscillating motor; fasten with screws.
The role of imported bearings in the way of oscillating motors and other aspects of the oscillating motor is a necessary change; and the way of thinking from a different point of view also has a certain change; gradually, the situation of various devices has also Must understand.

---

Recommend to friends comments close window

Bearing related knowledge

Characteristics of deep groove ball bearings and smooth method of using roller NSK bearing INA angle touch bearing bearing use - metal exercise and processing

This article links to http://
Please indicate China Bearing Network http://

Previous:How to clear the motor shaft next:The rolling bearing heating method and the key of the device

Steel Beam

Steel Beam,U Beam Channel Steel,S235JR Structural Material,Galvanized Beam Material

Torich International Co.,Ltd--The Steel Tube Maker , http://www.chinasteeltubepipe.com