LCX-type high viscosity pump Roots pump sub-belt drive and gear reducer drive in two forms.This pump has: low speed, high efficiency, small size, large flow, low power consumption, self-absorption ability, Easy to use and so on.It can be widely used in conveying petroleum and petroleum products (gasoline exchangeable copper pump leaf) and various kinds of oils and liquids in the factory such as crude oil, paint, lubricating oil, glass glue, oleic acid, toothpaste and alkali (Soap processing) liquid, etc .; food processing can transport a variety of liquids, such as soy milk, yeast, syrup, etc. Loading and unloading all kinds of tanker and tanker speed, high efficiency, easy to use, Check the oil level position, do not meet the requirements must be adjusted to meet the requirements to Roots pump operation, the oil level to the oil standard shall prevail 2, the oil change period according to the actual conditions of use and can meet the performance requirements and so on , At the discretion of the user.General new Roots pump, pumping clean and dry gas, it is recommended to change oil about 100 hours of work.When the oil can not see the black metal powder, oil extended after the period may be appropriate. , Regular inspection of oil quality, oil deterioration should be found in time Replace the new oil, to ensure Roots pump is working properly 4, under normal circumstances, the Roots pump work after 2000 hours should be overhauled to check the aging degree of sealing glue seal, check whether the exhaust valve cracking, cleaning sedimentation in the valve and Dirt on the exhaust valve seat Clean the parts of the entire Roots pump cavity, such as rotors, rotary vanes, springs, etc. Generally, wash with gasoline and dry.Wash dry the rubber parts with a dry cloth Clean the assembly should be gently and accidentally bump 5, Add bearing lubricating oil to the bearing body, observe the oil level should be at the center line of the oil, lubricating oil should be replaced or supplemented 6, Check the Roots pump pipeline And with or without loosening phenomenon. Rotating the Roots pump by hand to see whether the Roots pump is flexible. 7, reassembly should be carried out after the trial run, the general shall be empty for 2 hours and change the oil twice, Pump will be left a certain amount of volatile, to be functioning properly, and then put into normal work. 8, start the motor, when the Roots pump normal operation, open the outlet pressure gauge and import Roots pump, depending on their display after the appropriate pressure , Gradually open the gate valve, while checking the motor load situation 9, try to control the flow of Roots pump Volume and lift within the range indicated on the plate to ensure the Roots pump at maximum efficiency point of operation, in order to get the maximum energy-saving effect. 10, Roots pump to stop using, first close the gate valve, pressure gauge, and then stop the motor 11, Roots pump in operation, the bearing temperature can not exceed the ambient temperature 35C, the maximum temperature shall not exceed 80C. 12, Roots pump in the first month of work, after 100 hours to replace the oil, then every 500 hours , Oil change once. 13, often adjust the packing gland to ensure that the drip filling room is normal (with a drop of leakage is appropriate.) 14, regular inspection sleeve wear, wear larger should be promptly replaced. The long-term deactivated Pittsburgh pumps, the pump should be disassembled all, dry the water, the rotating parts and joints coated with grease installed, properly stored. 16, Roots pump in the winter season when used, after parking, the pump body Unclamp the lower part of the drain plug to drain the media.