The installation of the bathtub is usually a big problem in the bathroom decoration. Because the bathtub is a large part of the bathroom, a little carelessness will bring a lot of trouble to the later stage, so we must pay special attention to the installation method of the bathtub. In addition to paying special attention to waterproofing, there are more details on the installation of the bathtub. Today we are going to take a look at the installation method of the relevant bathtub.
1. Frame description: Dig a hole of 150mmx305mm at 340mm on the ground for drainage positioning.
2. Accessories installation: Install the overflow pipe section and the drain pipe section according to the manufacturer's instructions.
Note: Users can install horizontal drainage or vertical drainage as needed. After swinging the drain tee 90 degrees in the direction of the arrow, it can be horizontally drained by turning it 180 degrees in the plane.
3. Installation instructions: Put the bathtub in the groove, check whether the horizontal, front, rear and left and right positions are suitable, and check whether the ground drainage hole is appropriate. The bottom of the bathtub should be close to the smooth tiled floor to hold the bathtub just right.
Note: The brick wall support should be stable. When installing the bathtub, the bottom of the bathtub should be solid with the fine sand, and the bottom of the bathtub should not be supported by the brick to avoid damage to the glaze during use.
Check whether the level, front, back, and left and right positions are appropriate, check whether the drainage facilities are suitable, and install them stably. Take measures to prevent dirt, bumps, and clogging of the bathtub and the launching facilities during the installation process. Do not use sparks for angle grinders and spot welders. Splash on the bathtub, otherwise it will cause damage to the glaze and affect the appearance of the bathtub.
Item
Typical Alloys
Typical Temper
Specification (mm)
Round Bar
2014/2017/2024/2219
5052/5083
6063/6005/6005A/6008/6061/6082/6101
T4/T5/T6/T651/112/O/F
Dia.:38-110
>110-400
Rectangular bar
Width: 400-500
Thickness: 10-120
Special profile
Acc. To customer`s drawing
Acc. To customer`s drawing
7005/7050/7075/7055
Products Certificate:AS9100,IRIS, DNV,ABS, BV, TS16949, GJB9001B-2009,ISO9001,ISO14001, OHSAS18001, CNAS-CL01
Aluminium Extruded Profile,Aluminium Profiles,Aluminium Extrusion Profile,Extruded Aluminium Alloy Profiles
La Ya Aluminium products Co.,Ltd. , https://www.layametal.com