How to install the concrete pump tube, concrete pump to be installed in the test when the source of concrete. If it is commercial concrete, mixing and transport vehicles, delivery of wear-resistant pump tube can be installed locally, as long as the convenient take over and feeding can be. If the scene is mixed with concrete, first according to the site and mixing and machine feeding way to determine the mixing and machine position, and then according to mixing and machine discharge height and wear-resistant pump to send and take over the tube to determine the requirements to determine the concrete pump s position. 1, the first concrete pump placed on a solid concrete floor or stone pier, to maintain the degree, and the four legs of the pump positioning pin and safety pin locking, the tire off the ground or remove the tire. 2, according to the mix and the machine's discharge port and abrasion pump tube hopper to make a chute, mix and discharge the material through the chute into the pump hopper. 3, the chute is usually used for the skeleton angle, with 1.5mm thick steel welded together. Under the chute with a support frame, so that the solid. 4, under normal circumstances, in the wear-resistant pump tube hopper need to increase the height of about 20cm, so increase the hopper volume to ensure that concrete will not drain. Because the mandatory mix and machine unloading the best finish unloading, so that the concrete flow into the hopper symmetry. If the grading discharge, the last out of the concrete stones too much, on the pump unlucky, especially when the slump of concrete larger, it should be noted that the hopper pump to be raised. If it is a large volume of mixing and machine, you can make a storage hopper in advance to ensure continuous feeding. 5, placed in the chute, the required gradient, the most fortunate tilt angle between 25 ° -40 °, the gap should not be too large. 6, chute and pump hopper connection, chute and hopper to leave some space for easy cleaning hoppers and sieve. 7, the installation in place, look at the whole, to ensure that the wear-resistant pump tube casing door switch freely, easy maintenance.
Hot Melt Glue
high temperature hot melt glue,mid-temperature hot melt glue,low tmperature hot melt glue,hot melt adhesive
Sinowolf Plastic Dekor Co., Ltd , http://www.sinowolfdekor.com