Wood floor defects

At present, in the home renovation, the use of solid wood flooring in the use of the process, such as selection and improper laying, there will be some "common diseases", such as insects, quilting, noise, dirty boards, painted faces, drums and Qiu, etc. Now Discuss some diagnostic methods for these "disorders":

Insect mites: Because of the biting of insects in the wood, the pile of powder can often be seen on the surface of the floor, which is annoying. The reason is related to the floor selection. In order to prevent worms, the first choice is to purchase floors that have been produced through the kiln jet steaming process. Although the price is relatively expensive, all the eggs in the wood have been killed; the second is to carefully select the keel, and there are wormholes or bark. Never use it.

Quilting: Some floors have been spread over a few days and there has been a large gap between the slats. This is mostly related to the high moisture content before the laying of the floor, and it shrinks due to the high temperature or air drying in the room. Note that the moisture content of the floor prior to laying is in the range of 8% to 13%, and it must be oiled in time after laying.

Sound: Because of the poor quality of the floor, people will find buzzing noises when they walk around, and feel uncomfortable after hearing it. To this end, it is necessary to pay attention to the keel and the ground. The floor and the keel are firmly connected and the number and length of nails are appropriate. At the same time, to prevent the keel spacing is too large or the moisture content is too high, otherwise drying and shrinkage after laying will also have a certain impact.

Facial: Using the slats of the same species, the colors also appear to be quite different. If it is not properly laid, it will easily show a "face". When using varnish natural floor laying, especially when the species is extremely chromatic, you should consider the selection and deployment of the slats so that the floor color changes from shallow to deep, or gradually transitions from deep to shallow.

Drum: After some floors have been laid, they are swollen and damp. This is mostly related to the environment around the floor, especially the base tide or floor water. To ensure that the floor does not play drums, we must pay attention to three points: First, when the civil engineering project is just the result, the solid wood floor cannot be laid immediately; Second, if the living room is located in a humid environment, it is advisable to lay the floor; The moisture content of the floor cannot be less than 6%.