Please refer to the following precautions for the notes on replacing the molds in the tile maker:
1. The hydraulic system must be started under manual operation.
2. The upper die is raised to the upper limit position, the frame is raised to the upper limit position, and the lower die table is out of the forward limit position.
3, manually close the upper and lower mold, including the frame, loosen the upper mold and the frame of the binding bolt, the upper mold lifting platform rises to the rising limit, the frame lifting frame rises to the rising limit, the upper mold and frame left on the lower mold, Keep mold clamping.
4, the lower mold table back to the back limit, you can remove the original mold, the replacement mold will be placed on the lower die table
5. The lower die table advances to the forward limit position, initially adjusts the position, slowly lowers the upper die, carefully adjusts, aligns the position of the upper and lower die and the frame fixing hole, and fixes them respectively. Adjust the position of the proximity switch on the lower and upper sides of the frame and adjust the upper and lower limit positions of the upper mold. Lift the upper mold and frame. Check the condition of the lower mold filter. How to break should be replaced.
6. Lock the height of the quantifier and the feed level to the applicable position.
7. Adjust the relative height of the pallet frame and the upper mold to the proper position, that is, to ensure that there is a clearance of 0.5~1mm between the product and the pallet to tighten the screws.
Sodium Hexametaphosphate (SHMP)
Sodium Hexametaphosphate,Sodium Metabisulfite Bleach,Sodium Metabisulfite Loosening Agent,Sodium Metabisulfite Antioxidant Preservative
Shaanxi United Xingchuang International Co., Ltd. , https://www.lxcgj.com